Tweet
Hi All:
The boat has been completely sanded smooth with 80 grit followed by 220 on the orbital sander. I wiped everything down with Interlux Solvent 202 and then masked off the entire hull. I decided to paint the whole boat down to the water line. The rub rail and side trim piece are just too difficult to remove without removing the cabinet structures inside. I hope it will be an acceptable finish with them attached. The old gelcoat is very smooth. Tomorrow I will roll and tip the first coat of Interlux 404 Primer...
Here goes!
Bob
The boat has been completely sanded smooth with 80 grit followed by 220 on the orbital sander. I wiped everything down with Interlux Solvent 202 and then masked off the entire hull. I decided to paint the whole boat down to the water line. The rub rail and side trim piece are just too difficult to remove without removing the cabinet structures inside. I hope it will be an acceptable finish with them attached. The old gelcoat is very smooth. Tomorrow I will roll and tip the first coat of Interlux 404 Primer...
Here goes!
Bob
Comment